It was time to use all the left-over bits and pieces from die cuts. These left-over pieces are referred to as the negative spaces or pieces. This gold panel was one of the first left-over pieces from this gold foil paper pack. As you can see, I cut a square slightly larger than the oval die cut that I needed at the time. So, today I used the left-over for this card. What do you think?
Stamps:
Itty Bitty Greetings
Paper:
Fresh Freesia A-2
Gold Foil Paper 5 x 4, 1-7/8 x 2-3/4
Dainty Flowers DSP 3-15/16 x 4-15/16
Basic White 5-1/4 x 4 (Inside), 1/2 x 2-1/2
Ink:
Starry Sky
Technique:
Die Cutting
Punching
Accessories:
Classic Label Punch
Cross of Hope Framelits
Heirloom Frames & Dies
Adhesive
First, I cut a panel of DSP that was slightly smaller than the gold foil paper frame.
I adhered it, using some liquid adhesive.
I then attached this panel to the Fresh Freesia card front.
Next, I die cut a gold foil cross using the Cross of Hope Framelits and adhered it with adhesive.
I then stamped and punched out the sentiment and adhered it below the cross on the card front. I used liquid adhesive, but you can add some dimensionals, if you want it to pop.
Lastly, I adhered the Basic White panel to the inside of the card.
Thank you so much for stopping by here and spending a bit of your time. Please Contact Me if I can be of service.
Take a few minutes and Shop Now to browse through all of our current products. If you find something you want, please use the HOST CODE located in the right sidebar.
If you are looking for an all-inclusive kit at a reasonable price, check out Paper Pumpkin. This monthly subscription is satisfying for any crafter who only has a small amount of time for crafting, or is always on the go. Don't forget to take a peek at the Kits Collection for more options!
Join Me and take advantage of all the perks. Check it out today!
Please share, like, pin, tweet, or comment below and don't forget to FOLLOW and SUBSCRIBE to my blog.
HAPPY STAMPING!
No comments:
Post a Comment